Manual

Preparation
Use the remote control unit by pointing it towards the remote control sensor on the
TV. Objects between the remote control unit and the remote control sensor may
prevent proper operation.
, Do not expose the remote control unit to shock. In addition, do not expose the remote
control unit to liquids, and do not place inan area with high humidity.
, Do not install or place tile remote control unit in direct sunlight. The heat may cause
deformation of the remote control unit.
, The remote control unit may not work properly if the remote control sensor on the TV is in
direct sunlight or strong lighting. In such cases, change tile angle of the lighting or tile TV.
or operate the remote control unit closer to the remote control sensor.
,,I/
I
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections
that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector,
plug it into the antenna terminal at the rear of the TV set,
" "h f- _
1.A 75 ohm system is generallya round cablewittqan
F type connector that can easily be attached to a terminal
without tools (commercially available).
F-type connector
75-ohm coaxial (:able (round)
2.A 300 ohm system is a flat "bMn lead" cable that can be
attached to a 75 ohm terminal through a 300/75 ohm
adapter (commercially available).
300-ohm twin-lead cable (flat)
r ...................
Connecting Antenna Cable
Cable without a CATV Cab4e%fleadIn
converter
_u_ VHF/UHF antenna
VHF UHF
ANTENNA ANTENNA
Combination VHF/
UHF antenna
Separate VHF/UHF
antenna
_ F-type connector should be finger-
tightened only.
When connecting the RF cable to the TV set, do not
tighten the F-type connector with tools,
If tools are used, it may cause damage to your TV
set. (The breaking of internal circuit, etc.)
F-type connector
75-ohm coaxial cable
k.. ._
Home antenna
temqinai (75 ohm)
Coax;al cable
(commercialh/ available)
_'_75 Home antenna
ohm coaxial cable (_ound) temqinal (75 ohm)
Coaxial cable
(comrneroia/y available)
I300-ohm twin-I_d cable (flat)
3DN75 ohm adaptor
(commemially available)
To TV antenna
terminal
+ Connect the antenna cable
to the TV using one of the
methods in the illustration
as shown ((1_, (2_, _3_or (4_).
Q-12