Manual

QUICK REFERENCE
Use the remote control unit by pointing it towards the
remote control sensor on the 'f_/, Objects between
If the remote control fails to operate TV functions, the remote control unit and the remote control
replace the batteries in the remote control unit, sensor may prevent proper operation,
1 Open the battery cover,
2 Inser_ two "AAA" size batteries.
® Place the batteries with their terminals
corresponding to the (+) and ( ) indications
in the battery compartment,
3 Close the battery cover.
Improper use of batteries can result in chemical leakage
or explosion. Be sure to follow the instructions below.
Do not mix batteries of different types. Different types
of batteries have different characteristics.
Do not mix old and new batteries. Mixing old and new
batteries can shorten the life of new batteries or cause
chemical leakage in old batteries.
Remove batteries as soon as they are worn out.
Chemicals that leak from batteries that come in contact
wRh skin can cause a rash. If you find any chemical
leakage, wipe thoroughly with a cloth.
The batteries supplied with this product may have a
shorter life expectancy due to storage condRions.
if you will not be using the remote control unit for an
extended period of time, remove batteries from it.
30° * The angle is 6° when thestand is attached.
[] Cautions regarding the remote control unit
Do not expose the remote control unit to shock, in
addition, do not expose the remote control unit to
liquids, and do not place it in an area with high humidity.
Do not install or place the remote control unR under
direct sunlight. The heat may cause deformation of the
remote control unR.
The remote control unR may not work properly if
the remote control sensor on the TV is under direct
sunlight or strong lighting, in such cases, change the
angle of the lighting or the TV, or operate the remote
control unit closer to the remote control sensor.
x
iMPORTANT:
IF THE UNIT DOES NOT POWER ON - UNPLUG
THE TELEVISION FROM THE OUTLET AND REPE.:AT
THE INSTALLATION STEPS.
IF YOU STILL ENCOUNTER NO POWER, PLEASE
CONTACT US AT 1-800-BE-SHARP,
Cable without a
CATV converter
Preparation
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of ttqe types of
connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable wittq an
F4ype connector, plug it into ttqe antenna terminal at the rear of the TV set. For connecting the antenna cable to
ttqe TV, use commercially available cables.
f'Connecting Antenna Cable
• Connect the antenna cable to the "IV using one of the methods in the illustration as shown (_, _,
or _}. Home Antenna
Cable TV baddn terminal (75-ohm)
Coaxial cable
_7 Home Antenna
VHF/UHF antenna 5-ohm coaxial cable (round) fT_
terminal (75-ohm)
Coaxial cable
(._ Combination VHF/ "_!<_5-ohm coaxial cable (round)
UHF antenna
_ Separate VHF/UHF
antenna
UHF
To TV antenna
terminal
(_ 1,A 75-ohm system is generally a round cable with F-type connector
that can easily be attached to a terminal without tools.
2,A 300=ohm system is a flat "twin-bad" cable that can be attached
to a 75-ohm terminal through a 300/75-ohm adapter.
_ F-type connector should be
finger-tightened on_y,
When connecting the RF cable to the TV set, do not tighten
F-type connector wRh tools.
If tools are used, it may cause damage to your TV set. (The
breaking of internal circuR, etc.)
F-type connector
_(_ 75=ohm coaxial cable (round)
300=ohm twin-bad cable (flat)
75=ohm coaxial cable