Manual

On-Screen Display Menu
[] Updating the Software via the Network
1 Press A/T on the Manual Update screen to select
"Network Update", and then press ENTER.
• TheTV connectsto the networkandchecksfor updates.
• To cancel, pressENTER.
• Do not unplug the AC cord while the software is
being updated.
4
When the software is successfully updated, a
screen is displayed indicating that the update
process is completed.
A screen indicating that the update is completed
is displayed. 4 seconds later, the TV restarts
automatically.
2 The current version of the TV and the latest version
of software are displayed. To update the TV
software, select "Yes", and then press ENTER.
• If the software was not updated successfully, check the
broadband connection and Internet Setup, and then try
updating the software again.
• When a server connection cannot be established or an
update is not available, a message is displayed.
If a server connection cannot be established, check the
broadband connection and Internet Setup.
[] Updating the Software with a USB Memory Device
To check for the availability of a software update, visit
http://www.sharpusa.com/products/support/. If you
have any questions, please
call 1-800-BE-SHARP (800-237-4277).
o
o
Do not remove the USB memory device or unplug
the AC cord while the software is being updated.
Be sure to properly follow the whole procedure
described below, step by step, Otherwise, for
example, the "IV cannot read the data in the USB
memory device and software updating will fail.
Insert the USB memory device with the update file
into the USB 1 or USB 2 terminal on the TV.
• When you update the software, use only one USB
terminal. Either USB 1 or USB 2 is usable.
3 After the update file is downloaded, the software
update process begins.
!
2 Press A/T on the Manual Update screen to select
"USB Update", and then press ENTER.
(D- 38
D_ rtlo_ded _:_om www.ManualslJb.com mare als se{rch engine