Operation Manual, User's Manual

4-52
FACSIMILE►BASIC TRANSMISSION METHODS
CHANGING THE RESOLUTION
The resolution can be specified to match the characteristics of the original, such as text or photo, the size of the text, and
the darkness of the image.
Resolution settings
Resolution Suggestion
Standard Select this setting when your original consists of normal-sized text (like the text in this
manual).
Fine Select this setting when your original has small text or diagrams with fine lines.
The original will be scanned at twice the resolution of the [Standard] setting.
Super Fine Select this setting when your original has intricate pictures or diagrams.
A higher-quality image will be produced than with the [Fine] setting.
Ultra Fine Select this setting when your original has intricate pictures or diagrams.
This setting gives the best image quality. However, transmission will take longer than with
the other settings.
Half Tone Select this setting when your original is a photograph or has gradations of colour (such as a
colour original).
This setting will produce a clearer image than [Fine], [Super Fine], or [Ultra Fine] used alone.
Halftone cannot be selected when [Standard] is used.
•
When using the automatic document feeder, the resolution setting cannot be changed once scanning has begun. (However, when
"Job Build" or "Preview Setting" in "Others" is used, the resolution can be changed each time a new set of originals is inserted.)
• When a fax is sent at [Ultra Fine], [Super Fine], or [Fine] resolution, a lower resolution will be used if the receiving machine
does not have that resolution.
• Fax resolution setting
In "Settings (administrator)", select [System Settings] → [Image Send Settings] →[Fax Settings] → [Default Settings] →
[Resolution Setting].
The “Apply the Resolution Set when Stored” function saves the transmission resolution when saving a fax, and then uses
that resolution when resending the fax.
• If the image is distorted
In "Settings (administrator)", select [System Settings] → [Image Send Settings] →[Fax Settings] → [Default Settings] → [ECM].
You can enable ECM (Error Correction Mode) to automatically resend only the part of the image that was distorted.
If the receiving machine is a Super G3 machine, ECM will always operate, regardless of this setting.
• Super G3 Setting
In "Settings (administrator)", select [System Settings] → [Image Send Settings] →[Fax Settings] → [Default Settings] →
[Super G3 Setting].
This setting is set when the destination does not correspond to Super G3.