PN-R606 Dismantle Instruction LCD MONITOR MODEL Dismantle Instruction 1 PN- R606
PN-R606 Dismantle Instruction Table of contents 1. Scope.................................................................................................................. 3 2. Tools for dismantling............................................................................................... 3 3. Dismantle Procedure .............................................................................................. 3 4. Back covers .................................................................................
PN-R606 Dismantle Instruction 1. Scope This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU. 2. Tools for dismantling Below tools are required to dismantle this product. - Screw Driver Nipper 3. Dismantle Procedure This product can be dismantled by below steps. 1. Remove Back covers (section 4) 2. Remove the shielding 3. Remove Printed circuit boards (section 5) 4. Remove Battery (section 6) 5. Dismantle LCD (section 7) 6.
PN-R606 Dismantle Instruction 4. Back covers Back cover can be removed by screw driver.
PN-R606 Dismantle Instruction 5. Printed circuit boards All PWBs can be removed by screw driver. Main I/F PWB (1pcs) Power PWB (1pcs) T-CON PWB (1pcs) OPS PWB (1pcs) LED driver PWB (1pcs) 6. Battery This model uses AAA battery for remote control and CR2032 Lithium Coin battery on Main I/F PWB. -The remote control battery can be easily removed. -The battery CR2032 on the main I/F PWB can be easily removed from the battery holder.
PN-R606 Dismantle Instruction 7. LCD Module - LCD Dismantle procedure 1. Remove Rear cover 2. Remove PWBs and Tray 3.
PN-R606 Dismantle Instruction 8. Capacitors Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB. These capacitors can be removed by using nipper to cut the leads. On Power PWB 9. Parts List Parts described in Annex VII of directive 2012/19/EU are as below.
