Operation Manual

32
E
RS-232C command table
How to read the command table
Command: Command eld (See page 31.)
Parameter: Parameter eld (See page 31.)
* : Enter the number in brackets in the settings
: Enter a space
TIPS
• In the standby mode, the only command that is used is POWER CONTROL.
The operation of commands not indicated in the table below is not guaranteed.
Function Command Parameter Settings
POWER
CONTROL
P O W R 0
Switches to standby mode.
P O W R 1
Enters the power ON state.
INPUT MODE
SELECTION
I T G D
Toggle change for input mode.
I A V D *
Change to the INPUT1 to 5 terminal. (1 - 5)
PICTURE MODE
SELECTION
A V M D 0
Toggle change for PICTURE MODE.
A V M D 1
STANDARD
A V M D 2
MOVIE
A V M D 5
DYNAMIC
A V M D 6
DYNAMIC (FIXED)
A V M D 7
PC
VOLUME V O L M * * *
Set the volume. (0 - 100)
SCREEN H P O S * * *
Adjust the horizontal position of the image. (000 - 180) (D-SUB (PC))
V P O S * * *
Adjust the vertical position of the image. (000 - 120) (D-SUB (PC))
C L C K * * *
Set the frequency of the sampling clock of the picture. (000 - 180)
(D-SUB (PC))
P H S E * * *
Adjust the phase of the sampling clock of the picture. (000 - 015)
(D-SUB (PC))
SCREEN SIZE* W I D E 0
Toggle change for screen size.
W I D E 7
NORMAL
W I D E 9
WIDE
W I D E 1 0
Dot by Dot
W I D E 1 1
UNDERSCAN
MUTE M U T E 0
Toggle between mute and unmute.
M U T E 1
Mute.
M U T E 2
Unmute.
MODEL M N R D 0 0 0 1
SERIAL NO S R N O ? ? ? ?
INPUT
RESOLUTION
CHECK (PC)
P X C K
Returns current resolution in the form of hhh, vvv.
INPUT
RESOLUTION
CHECK (AV)
R E S O
480i, 480p, 1080i, 720p, 1080p, VGA , etc.
* When the screen size is changed automatically using HDMI AUTO WIDE, the current value is not an auto sized value but a
value set manually.
Controlling the Monitor with a PC (RS-232C)