PN-V701 Dismantle Instruction LCD MONITOR MODEL Dismantle Instruction 1 PN-V701
PN-V701 Dismantle Instruction Table of contents 1. Scope.................................................................................................................. 3 2. Tools for dismantling............................................................................................... 3 3. Dismantle Procedure .............................................................................................. 3 4. Back covers .................................................................................
PN-V701 Dismantle Instruction 1. Scope This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU. 2. Tools for dismantling Below tools are required to dismantle this product. - Screw Driver Nipper 3. Dismantle Procedure This product can be dismantled by below steps. 1. Remove Back covers (section 4) 2. Remove Printed circuit boards (section 5) 3. Remove Battery (section 6) 4. Dismantle LCD (section 7) 5.
PN-V701 Dismantle Instruction 4. Back covers 2 back covers (right/left) can be removed by screw driver.
PN-V701 Dismantle Instruction 5. Printed circuit boards All PWBs can be removed by screw driver.
PN-V701 Dismantle Instruction 6. Battery This model uses only CR2032 Lithium Coin battery on Main I/F PWB. Battery CR2032 can easily be removed from the battery holder.
PN-V701 Dismantle Instruction 7. LCD Module - LCD Dismantle procedure After you have removed the PWB’s, please take out the cables from the LCD module.
PN-V701 Dismantle Instruction 8. Capacitors Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB, LED driver PWB and 5V Power PWB. These capacitors can be removed by using nipper to cut the leads.
PN-V701 Dismantle Instruction 9. Parts List Parts described in Annex VII of directive 2012/19/EU are as below.
