Operation Manual, User's Manual

4-4
FACSIMILE►BEFORE USING THE MACHINE AS A FAX
2
Make sure the main power switch is in the " " position.
When the main power indicator is lit up, the main power is in the " " position. If the main power indicator is not lit up,
turn the main power switch to the " " position and press the [POWER] button on the operation panel.
► TURNING ON THE POWER (page 1-8)
When “Settings (administrator)” – [System Settings] → [Image Send Settings] → [Fax Settings] → [Condition Settings]
→ [Auto Wake Up Print] is enabled, the power automatically turns on when a fax is received (even if the [Power] button
is off), and the fax is printed. When [Auto Wake Up Print] is disabled and the [Power] button is on, received faxes are
stored in memory and are not printed until the power is turned on.
If the fax function will be used, and in particular if reception or timer transmission will take place at night, do not turn the
main power off.
3
Setting the telephone line type.
The machine's dial mode setting must be set to match the type of telephone line you are using.
* If the setting is incorrect, it may result in dialling failures or cause calls to be made to the wrong destination.
• If you want to set the type of telephone line automatically
In "Settings (administrator)", select [System Settings] → [Image Send Settings] → [Fax Settings] → [Default Settings]
→ [Dial Mode Setting], and tap the [Auto Select] key.
• If necessary, you can set the type of telephone line manually.
• This setting can only be activated in Canada.
• When you connect to a digital line When Digital Line Network is enabled, the send level will be 15 dB or less when you
connect to a digital line. In "Settings (administrator)", select [System Settings] → [Image Send Settings] → [Fax
Settings] → [Default Settings] → [Digital Line Network].
4
Checking the date and time.
Verify that the correct date and time are set in the machine.
To set the date and time of the machine:
In "Settings", select [System Settings] → [Common Settings] → [Device Control] → [Clock Adjust].
If [Disabling of Clock Adjustment] has been enabled, the date and time cannot be modified.
In "Settings (administrator)", select [System Settings] → [Common Settings] → [Device Control] → [Enable/Disable
Settings] → [Disabling of Clock Adjustment], and cancel the adjustment disabling setting.
5
Storing the sender fax number.
Store a sender name in [Sender Name] and a fax number in [Fax No.]. Be sure to configure this information, as it is
required for communication.