Operation Manual, User's Manual

5-120
SCANNER/INTERNET FAX►OTHER FUNCTIONS
7
Specify the time (hour and minute) in 24-hour format.
After the settings are completed, tap and [Back] keys in sequence.
Tap the areas displaying the hour and minute respectively, and enter the values using the numeric keys.
It is convenient to use to finely adjust the time.
The setting will show the current time. If the time is not correct, press the [CA] key to cancel the operation. Correct the
time in setting mode and then perform the timer transmission procedure.
BEFORE USING THE MACHINE AS A NETWORK SCANNER FUNCTION
(page 5-4)
To cancel the Timer Transmission settings:
Tap the [Off] key.
To set the date and time of the machine:
In "Settings", select [System Settings] → [Common Settings] → [Device Control] → [Clock Adjust].
If [Disabling of Clock Adjustment] has been enabled, the date and time cannot be modified. Select [System Settings] in
"Settings (administrator)" and select [System Settings] → [Common Settings] → [Device Control] → [Enable/Disable
Settings] to disable the [Disabling of Clock Adjustment] setting.
8
Tap the [Start] key to start scanning of the original.
If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning has ended, and the machine stands by for transmission.
When you place the original on the document glass, scan each page one at a time.
When scanning finishes, place the next original and tap the [Start] key.
Repeat until all pages have been scanned and then tap the [Read-End] key.
A beep will sound to indicate that scanning has ended, and the machine stands by for transmission.
You can tap the [Preview] key to check a preview of the image before sending an image. For more information, see
"CHECKING THE IMAGE TO BE TRANSMITTED (page 5-69)
" (When in fax mode, "CHECKING THE IMAGE TO BE
TRANSMITTED (page 4-29)").
The original is scanned into memory. The original cannot be scanned at a specified time.