Operation Manual, User's Manual

7-90
SETTING MODE►SYSTEM SETTINGS
IEEE802.1X Setting
IEEE802.1X can be used to authenticate a user to allow use of the machine.
IEEE802.1X protocol defines port-based authentication for both wired and wireless networks.
Use IEEE802.1X authentication to allow only authenticated devices to use network, and protect against network abuse
by third parties.
You can enable or disable IEEE802.1X authentication with this setting. The IEEE802.1X details can be set with Setting
mode (Web version). Depending on the Web page settings, connection to the machine may not be allowed, or the
settings may not allow printing, scanning, or Setting mode (Web version) display. In this case, deselect this setting and
change the Setting mode (Web version) settings.
IEEE802.1X Authentication
Set whether IEEE802.1X authentication is used.
EAP Authentication Method
Set the EAP authentication method in IEEE802.1X.
EAP User Name
Enter a maximum of 64 full-width/half-width characters for the EAP user name used for authentication.
Password
Enter a maximum of 64 half-width characters for the EAP password used for authentication.
Server Authentication
Set whether server authentication is used.
EAP Timeout
Set the EAP Timeout.
Number of EAP Retries
Set the number of EPS re-access times when transmission fails.
Certificate Status
Shows the status of the certificate required for transmission using IEEE802.1X. To install a certificate, click [Install].
CA Certificate Status
Shows the status of the CA certificate required for transmission using IEEE802.1X. To install a certificate, click [Install].