Dismantle Instruction LCD MONITOR MODEL PN-65TH1 Dismantle Instruction 1
Dismantle Instruction Table of contents 1. Scope ............................................................................................................... 3 2. Tools for dismantling............................................................................................. 3 3. Dismantle Procedure ............................................................................................ 3 4. Back covers ........................................................................................
Dismantle Instruction 1. Scope This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU. 2. Tools for dismantling Below tools are required to dismantle this product. - Screw Driver Nipper 3. Dismantle Procedure This product can be dismantled by below steps. 1. Remove Back covers (section 4) 2. Remove the shielding 3. Remove Printed circuit boards (section 5) 4. Remove Battery (section 6) 5. Dismantle LCD (section 7) 6.
Dismantle Instruction 4. Back covers Back covers can be removed by screw driver.
Dismantle Instruction 5. Printed circuit boards All PWBs can be removed by screw driver.
Dismantle Instruction 6. Battery This model uses CR2032 Lithium Coin battery on Main I/F PWB and AAA battery for remote control. Battery can easily be removed from the battery holder.
Dismantle Instruction 7. LCD Module LCD Dismantle procedure 1. Remove the Brackets for touch panel mounting 2. Remove the Touch panel 3. Remove the Rear cover 4. Remove the PWBs 5.
Dismantle Instruction 8. Capacitors Electrolyte Capacitors which diameter/height is larger than 25mm is installed on the Power PWB. These capacitors can be removed by using nipper to cut the leads. 9. Parts List Parts described in Annex VII of directive 2012/19/EU are as below.
