Dismantle Instruction

ManualsBrandsSharp ManualsSolarLC40LE240EX

PN-86HC1 Dismantle Instruction

LCD MONITOR

MODEL

PN-86HC1

Summary of content (8 pages)

PAGE 1
PN-86HC1 Dismantle Instruction LCD MONITOR MODEL PN-86HC1 Dismantle Instruction 1
PAGE 2
PN-86HC1 Dismantle Instruction Table of contents 1. Scope ............................................................................................................... 3 2. Tools for dismantling............................................................................................. 3 3. Dismantle Procedure ............................................................................................ 3 4. Back covers ...............................................................................
PAGE 3
PN-86HC1 Dismantle Instruction 1. Scope This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU. 2. Tools for dismantling Below tools are required to dismantle this product. - Screw Driver Nipper 3. Dismantle Procedure This product can be dismantled by below steps. 1. Remove Back covers (section 4) 2. Remove the shielding 3. Remove Printed circuit boards (section 5) 4. Remove battery (section 6) 5. Dismantle LCD (section 7) 6.
PAGE 4
PN-86HC1 Dismantle Instruction 4. Back cover Back cover can be removed by screw driver.
PAGE 5
PN-86HC1 Dismantle Instruction 5. Printed circuit boards All PWBs can be removed by screw driver.
PAGE 6
PN-86HC1 Dismantle Instruction 6. Batteries This model uses CR2032 Lithium Coin battery on MAIN PWB. Battery CR2032 can easily be removed from the battery holder. This model uses AAA battery for remote control. Battery can easily be removed.
PAGE 7
PN-86HC1 Dismantle Instruction 7. LCD Module bezels/bracket - LCD Dismantle procedure 1. Remove screws 2. Remove Cover glass and Bezels 3. Remove screws 4. Remove Middle Frame 5. After you have removed the PWB´s, the cover glass and bezels please take out the cables from the LCD module.
PAGE 8
PN-86HC1 Dismantle Instruction 8. Capacitors Electrolyte Capacitors which diameter/height is larger than 25mm is installed on the Power PWB. These capacitors can be removed by using nipper to cut the leads. 9. Parts List Parts described in Annex VII of directive 2012/19/EU are as below.