Operation Manual, Troubleshooting

12
General Problems
Is the detection range set correctly? Adjust the detection range.
PRINTING IS NOT POSSIBLE OR STOPS DURING
A JOB
Check Solution
Is a tray out of paper? Add paper as instructed by the message in the touch panel.
Is the machine out of toner? Replace the toner cartridge.
Maintenance
(page 6)
Has a paper misfeed occurred? Remove the misfeed as instructed by the message in the touch panel.
Is the output tray full? Remove the output from the tray and resume printing.
When the output tray becomes full, a detector activates and stops printing.
Is the waste toner box full? Replace the waste toner box as instructed by the message in the touch panel.
Are restrictions placed on the trays
that can be used in each mode (copy,
print, image send, and document
filing)?
Check the settings in [Paper Tray Settings] and see if checkmarks appear in the
checkboxes of each mode ([Feeding Approved Job]).
Functions without a checkmark cannot be used for printing using that tray.
"Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration] → [Feeding Approved Job]
Check Solution
!
Motion sensor
Near Far
?
!