Operation Manual, Troubleshooting

8
General Problems
THE PAPER MISFEEDS
Is tray 1 properly inserted all the way into the machine? 13
Is a torn piece of paper remaining in the machine? 13
Is too much paper loaded in the tray? 13
Are multiple sheets feeding at once? 13
Are you using paper that is not within the specifications? 13
Are the tray guides adjusted to the width of the paper? 13
Is the feed roller dirty? (Tray 1, bypass tray) 13
Is the paper size specified? 14
Did you add paper to tray? 14
Are you using punched paper? 14
Are you using label sheets that cannot be used? 14
Remove the paper, turn it over, and reload it. Using a different paper
type may solve the problem.
14
Have you forgotten to remove the divider plate even though A4 size
paper is loaded in tray 1?
14
Does the machine recognize the paper size even though 8-1/2" x 14"
size is correctly loaded in tray 2 to 5?
14
THE OUTPUT SCATTERS
Is the output extension tray extended? 14
PAPER DOES NOT FEED FROM
THE PAPER TRAY
Is the paper loaded correctly into the paper tray? 15
Has the tray been prohibited in some modes (copy, print, fax, image
send, document filing)?
15
I DON'T KNOW HOW TO CHANGE
THE PAPER SIZE
Set the paper size used in each tray in the tray settings. 15
THE OUTPUT IS NOTICEABLY
CURLED AND UNEVEN
Remove the paper, turn it over, and reload it. Using a different paper
type may solve the problem.
15
THE IMAGE IS SKEWED ON THE
PAPER
Is too much paper loaded into the bypass tray? 16
Are the tray guides adjusted to the width of the paper? 16
Are the original guides adjusted to the width of the paper? 16
LINES APPEAR IN THE IMAGE
Are the scanning areas of the document glass or automatic document
feeder dirty?
16
Is the bypass feed roller dirty? 16
Did you clean the main charger of the photoconductive drum? 16
Did you clean the laser unit? 16
Did you execute Black Streak Reduction of system setting? 16
SMUDGES APPEAR ON PRINTED
OUTPUT
Are you using paper that is not within the specifications? 17
Are you printing on pre-punched paper? 17
Does a message appear indicating the need for maintenance? 17
Remove the paper, turn it over, and reload it. Using a different paper
type may solve the problem.
17
WHEN PRINTING ON THICK PAPER,
THE PRINT RESULT IS DIRTY FROM
THE 2ND PAGE ON
Has the paper type been set correctly? 17
PART OF THE IMAGE IS CUT OFF
Has the correct paper size been set? 18
Was the original placed in the correct position? 18
Does the original size shown on the touch panel match the actual size
of the original?
18
PRINTING TAKES PLACE ON THE
WRONG SIDE OF THE PAPER
Is the paper loaded with the print side facing in the correct direction? 18
A COVER OR INSERT IS NOT
PRINTED ON THE SPECIFIED
PAPER
Has the paper type been set correctly? 18
Problem Check Page
?