Operation Manual, User's Manual

1-106
BEFORE USING THE MACHINE►LOADING PAPER
4
Insert the paper (print face down) all
the way into the bypass tray.
To prevent a misfeed, verify once more that the paper
guides are adjusted to the width of the paper.
• For "Letter Head" and "Pre-Printed", set the paper with the print side up. However, when [Disabling of Duplex] is
enabled, set the print side in the same orientation as in the regular mode (facing down).
• To add paper, press down the pressure plate until it locks, remove any paper remaining in the bypass tray, combine it
with the paper to be added, and place in the bypass tray again. If paper is added without removing the remaining
paper, a paper jam may result. A paper jam may also result if more than the specified number of sheets are added, or
if the paper stack exceeds the limit.
• Do not forcefully push in paper that you are loading. This may cause misfeeds.
• If the bypass tray guides are set wider than the paper, move the bypass tray guides in until they correctly fit the width
of the paper. If the bypass guides are set too wide, the paper may skew or be creased.
• How to close the bypass tray.
Remove any paper remaining in the bypass tray, and press down the center of the pressure plate until it locks. After
you have locked the pressure plate, close the extension tray and then close the bypass tray.
To display the paper tray settings when paper is detected in the bypass tray
In "Settings", select [System Settings] → [Common Settings] → [Paper Settings] → [Paper Tray Settings] → [Display
Paper Tray Settings when bypass tray detects paper.].