70" (175cm) Quattron Full HD LED LCD TV Manual

Preparation

Attaching the stand unit

• Before performing work, spread cushioning over the surface

on which you will be laying the TV. This will prevent it from

being damaged.

CAUTION

• Attach the stand in the correct direction.

• Be sure to follow the instructions. Incorrect installation

of the stand may result in the TV falling over.

1 Confirm that there are twelve screws (eight long

screws and four short screws) supplied with the

stand unit.

2 1 Set the supporting post for the stand unit onto

the polystyrene foam.

2 Attach the stand base to the supporting post.

3 Insert and tighten the eight screws into the

eight holes on the bottom of the stand base.

• Hold the stand unit securely with one hand, and

then tighten the screws.

Stand base Long screws

TV front

Supporting post

3 Insert the stand into the openings on the bottom

of the TV (hold the stand so it will not drop from

the edge of the base area).

• Make sure that the stand is firmly inserted into the TV.

Improper installation may result in tilting of the TV set.

Soft cushion

4 Insert and tighten the four screws into the four

holes on the rear of the TV.

Short screws

NOTE

• To detach the stand unit, perform the steps in reverse order.

• A screwdriver is not supplied with this product.

• In the installation procedure, be careful not to catch your

fingers between the TV set and the floor.