Installation Manual RESU 10H DLT Type-C

21
3.1.9 Installing the battery pack
1. Fix the lift handles to the hex-socket
screws on the rear (marked position)
of both left and right sides.
2. Mount the wall bracket to a wall.
Tighten the screws, ensuring that they
are horizontally driven into the wall.
(Must be installed with recommended
clearances(720mm[29"]) on the edge of the
wall bracket as shown in the figure)
3. Mount the battery pack to a wall bracket’s
“U” shape clip using the support by lift
handles. Remove the lift handles.
When installing the battery pack with lift
handle, It is heavy to install around
100kg. Be sure to remove the obstacles
from the surroundings and lift the battery
pack with two people at the same time
CAUTION
Make sure that the inverter AC and DC disconnects are turned off before
connection the power cable to the battery pack.