Installation Manual RESU 10H DLT Type-C

22
4. Tighten the two hex-socket screws enclosed
and remove the lift handles. The nuts for these
screws are welded to the battery pack chassis.
Tighten to a torque of 5 N•m using the
M6 torque wrench.
5. Press the two buttons and pull the two latches
(marked position) on the rear side of the wiring
box cover (hinged door).
6. Open the wiring box cover (about 2~10 degrees),
and pull to remove it.
CAUTION
The wiring box cover is heavy.
[approx. 1.6kg(3.5lb)] If dropped it
may cause injury.