RESU 10M
Application
Energy Retention
Nominal Energy
Aggregate Throughput
Self-consumption,
Back-up
60% of nominal energy
at 10 years from warranty
term commencement date
9.8kWh
29.25MWh
The value of energy aggregate throughput and retention shall be measured on the following conditions
by ‘LG Chem’, when warranty validation is required by ‘Buyer’.
Capacity measurement condition
Ambient temperature: 25~30℃
Initial battery temperature from BMS: 25~30℃
Charging/discharging method
- Charge: 0.3CC/CV, Cut-off current 0.05C at 174.6V
- Discharge: 0.3CC, Cut off voltage 126V or cut-off min. cell voltage 3V
- Current and voltage measurement at battery side
5. Notification of Defect and Identification of Cause
5.1 The ‘Buyer’ shall promptly notify their Reseller or ‘LG Chem' if any of the ‘Products’ are found
to be defective or if any quality-related problems are raised due to the defect. The same shall apply if
the ‘Products’ do not meet the performance as described in Article 4.
5.2 If the ‘Buyer’ intends to raise a claim due to the quality defect of the ‘Products’, the ‘Buyer’
shall provide LG Chem with each of the following information.
(1) Proof of the purchase
(2) Symptoms of the defect and when it occurred
(3) Serial number of the ‘Products’
5.3 ‘LG Chem’ should promptly identify the defect notified by ’Buyer’, and repair or replace the
defect under warranty by using an objective inspection method.
6. Replace or Repair
6.1 If 'LG Chem' is found to be liable for the defect of the 'Products' under Article 5, ‘LG Chem’
shall finally decide whether to (i) repair the defective ‘Products’, or (ii) replace the defective
‘Products’ with intact parts that are free of any defects and equal in value.
6.2 The warranty period for the repaired or replaced part shall be the remainder of the warranty
period for the original parts.
6.3 ‘LG Chem' shall not indemnify or compensate for any damages unless otherwise explicitly
specified herein.