Setup Manual LLS201A

8
E
Turning Power ON/Off
Turning on the power
1. Press the POWER button.
Power LED
Press
POWER button
The power LED turns on.
2. Turn on the PC.
The screen appears.
Status Status of the monitor
Green lit Signal input
Orange lit No signal input
Turning off the power
1. Turn off the PC.
2. Depress the POWER button for around 2 seconds.
Depress for around
2 seconds
POWER button
The power LED turns off.
Caution
• If the monitor will not be used for a long time, disconnect
the power plug from the power outlet.
Specications
Model LL-S201A
Power requirement AC 100 V - 240 V, 50/60 Hz (when using the supplied AC adapter)
Operating temperature 32°F to 95°F (0°C to 35°C)
Operating humidity 20% to 80% (no condensation)
Power consumption 35 W
Dimensions (excluding protrusions) inch (mm)
Approx. 18-1/4 (W) x 1 (D) x 10-13/16 (H) (463.8 x 25.2 x 274.8)
Weight lbs. (kg)
Approx. 5.07 (2.3) (excluding the stand)
Approx. 6.39 (2.9) (including the stand)
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specication changes for product improvement
without prior notice. The performance specication gures indicated are nominal values of production units. There may be some deviations from
these values in individual units.
n
Operation mode
When the monitor is turned on for the rst time after being shipped from the factory, the operation mode setting screen will be
displayed. Set it to MODE1 or MODE2.
MODE1 ....If there is no operation for 4 hours or more, the monitor automatically enters standby mode. Power consumption in
standby mode is also minimized.
MODE2 ....Will perform standard operation.
Even after being set, changes can be made using [Operation mode], located in the menu of the monitor. (See OPERATION
MANUAL.)