Service manual

– 26 –
MD-MT180
SW401 EJECT OFF—ON
SW403 LID OPEN OFF—ON
SW601 DISC PROTECT OFF—ON
NOTES ON SCHEMATIC DIAGRAM
• Resistor:
To differentiate the units of resistors, such symbol as K and
M are used: the symbol K means 1000 ohm and the symbol
M means 1000 kohm and the resistor without any symbol is
ohm-type resistor. Besides, the one with “Fusible” is a fuse
type.
• Capacitor:
To indicate the unit of capacitor, a symbol P is used: this
symbol P means micro-micro-farad and the unit of the
capacitor without such a symbol is microfarad. As to electro-
lytic capacitor, the expression “capacitance/withstand volt-
age” is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
• The indicated voltage in each section is the one measured
by Digital Multimeter between such a section and the chas-
sis with no signal given.
• Parts marked with “ ” ( ) are important for
maintaining the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.
POSITION
REF. NO
DESCRIPTION
HRB0103B
2SB1462 J
2SD1819 AS
DTC123 TKA
KTA2015 Y
MCH3409
UN5210
UN5213
TOP
VIEW
TOP
VIEW
TOP VIEW
F10J2E
F05J2L
TOP VIEW
B
(G)
(3)
E
(S)
1
C
(D)
(2)
MA132WK
2SJ520 TL
GD
S
TOP VIEW
SBE803
XP01401
TOP VIEW
RB731U
TOP VIEW
Figure 26 TYPES OF TRANSISTOR AND DIODE