Specifications

12
RECORDING
ENGLISH
Recording with the Built-in
Microphone
Before recording with the built-in mono microphone,
make sure the following switches are set correctly.
INPUT SELECT
Set the INPUT SELECT switch to ANALOG, while unit is
stopped. “Analog in” appears in the display.
INPUT LEVEL
Set the INPUT LEVEL switch to MIC.
SOURCE
Set the SOURCE switch to INT MIC.
Recordings made via the built-in microphone are always
mono.
Recording with External
Microphones
Before recording with microphone(s) connected to the
MIC/LINE IN jack(s), make sure the following switches
are set correctly.
INPUT SELECT
Set the INPUT SELECT switch to ANALOG.
“Analog in” appears in the display.
INPUT LEVEL
Set the INPUT LEVEL switch to MIC.
SOURCE
Set the SOURCE switch to specify the kind of source you
are recording and the corresponding input jacks.
• STEREO: To record in stereo via the MIC/LINE IN (L) and
(R) jacks.
• MONO (Lch): To record a mono source via the MIC/LINE
IN (L) jack.
ANC
Set the ANC (Ambient Noise Control) switch to filter out
unwanted frequencies when recording.
• (band-pass): Cuts low frequency (125 Hz and lower)
and high frequency (3 kHz and higher) signals.
• FLAT: Normal frequency characteristics.
• (high-pass): Cuts low frequency (125 Hz and lower)
signals.
Types of sound cut off by ANC
Wind, rumbling, etc.
MIC ATTENUATION
Set the MIC ATTEN switch according to the level of the
signal you are recording. This allows you to compensate
for high level signals and/or noisy environments that
can not be compensated for using the REC LEVEL
adjustments. This setting will effect the recording level.
Be sure to set this switch before adjusting the recording
level.
• 0 dB : No attenuation
• –15 dB : 15 dB attenuation
• –30 dB : 30 dB attenuation
SOURCE
SP LP
OFF ON
REC MODE
0dB
-15dB
MIC ATTEN
FLAT
ANC
-30dB MIC LINE
INPUT LEVEL
INPUT SELECT
STEREO
HP/SPK MODE
REC LEVEL
LSR
MANUAL
STEREO INT MIC L R
MONO (L ch)
ANALOG DIGITAL
LIMITER
ALC
SOURCE
SP LP
OFF ON
REC MODE
0dB
-15dB
MIC ATTEN
FLAT
ANC
-30dB MIC LINE
INPUT LEVEL
INPUT SELECT
STEREO
HP/SPK MODE
REC LEVEL
LSR
MANUAL
STEREO INT MIC L R
MONO (L ch)
ANALOG DIGITAL
LIMITER
ALC