User Manual

7-164
SYSTEM SETTINGS►SYSTEM SETTINGS
Change transition time by time of day.
This function controls the transition to Auto Power Shut-Off mode optimally for each time period by analyzing the use of
the machine based on job logs obtained during a 4-week period.
When this setting is enabled, the [Fix transition time.] option is disabled.
Transition to Energy Saving and Auto Power Shut-Off modes
* Factory default setting
Automatic
This function controls the power optimally for each time period by analyzing the use of machine based on job logs
obtained during a certain time period.
• The image transfer control settings are not changed.
• This does not link to the Power On/Off Scheduling. If both of them are enabled, the Power On/Off Scheduling settings
precede.
• Pages are counted for each paper size separately.
• When the power supply of the machine was off, there was no job during this time.
Pattern Transition time Average outputs per
hour
*
Mode1 (Job Start
Priority1)
After 1 hour 700 or more
Mode2 (Job Start
Priority2)
After 30 minutes 150 to 699
Mode3 (Energy Saving
Priority1)
After 5 minutes 40 to 149
Mode4 (Energy Saving
Priority2)
After the minimum time period Up to 39
Sleep Mode Power
Level
Low Power : The machine switches to the power saving mode,
but it takes some time to recover.
Fast Wake Up : Compared with Low Power, the power value rises
by a certain degree, but it results in faster
recovery.
Motion Sensor (MX-3060N/MX-3070N/MX-3560N/MX-3570N/
MX-4060N/MX-4070N/MX-5070N/MX-6070N):
This enables switching of power saving modes by
the motion sensor.
–
If the machine does not have the 4-week job log information, the machine enters the template2 (Mode3 (Energy Saving
Priority1) between 8:00 and 18:00 hours). Then after that, it enters Mode4 (Energy Saving Priority2).