Owner's Manual

48
6
Press the [COLOR START] key ( )
or the [BLACK & WHITE START] key
().
Scanning begins.
If the original is placed on the document glass, the
[Read-End] key appears in the touch panel. To scan only one
original, go to step 8. To scan multiple originals, go to the
next step.
If the original was inserted in the document feeder tray, a
beep will sound when scanning is completed and
transmission will begin. Go to step 9.
Do not disconnect the USB memory until "Sending data has been completed." appears in the touch panel.
To scan in full color, press the [COLOR START] key ( ). To scan in black and white, press the [BLACK &
WHITE START] key ( ). If the color mode of the [COLOR START] key ( ) is set to [Auto], the color of the
original will be detected automatically and scanning in full color, grayscale or Mono 2 will take place.
If the file type is [Encrypt PDF], a password entry screen will appear when the [START] key is pressed.
Touch the [Entry] key to open the keyboard screen, enter a password (maximum of 32 characters), and touch the
[OK] key. The recipient must use the password entered here to open the encrypted PDF file.
To cancel encrypted PDF, touch the [Cancel] key. The format settings screen will appear to let you change the file
type. Select a new file type and press the [START] key to begin transmission.
7
If the original was placed on the
document glass, replace it with the next
original and press the [COLOR START]
key ( ) or the [BLACK & WHITE
START] key ( ).
Repeat until all originals have been scanned.
The exposure, resolution, and scan size/send size can be changed for each original page that is scanned.
8
Touch the [Read-End] key.
A beep will sound to indicate that the operation is completed.
Open the automatic document feeder and remove the original.
If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the
transmission is reserved.
or
Please enter encrypt PDF
password.
Cancel Entry
or
Place next original. (Pg.No.x)
Press [Start].
When finished, press [Read-End]
Read-End