Owner's Manual

36
* When a saddle stitch finisher is installed.
■ Network Settings
X Initial Margin Shift Setting
66 Side 1 1/2"
 Side 2 1/2"
X Erase Width Adjustment
66 Edge Clearance Width 1/2"
 Center Clearance Width 1/2"
X Card Shot Settings
66 Original Size X: 3-3/8", Y: 2-1/8"
 Fit to Page Disabled
X Automatic Saddle Stitch* Enabled 66
X Initial Tab Copy Setting 1/2" 66
X Disabling Deletion of Job Programs Disabled 67
X Disabling of Bypass-Tray in Duplex Copy Disabled 67
X Disabling of Auto Paper Selection Disabled 67
X Auto Selection Setting of Tray that is Supplied the Paper Disabled 67
X B/W 600dpi x 600dpi Scanning Mode for Document Feeder Disabled 67
X B/W Quick Scan from Document Glass Enabled 67
● Color Adjustments 68
X Initial Color Balance Setting Factory default state 68
X Auto Color Calibration – 68
Item Factory default setting Page
■ Network Settings
69
● IP Address Setting DHCP 69
● Enable TCP/IP Enabled 69
● Enable NetWare Enabled 69
● Enable EtherTalk Enabled 69
● Enable NetBEUI Enabled 69
● Reset the NIC – 69
● Ping Command – 69
Item Factory default setting Page