Specifications
Table Of Contents
- INTRODUCTION
- CONTENTS
- USING THE MANUAL
- DIFFERENCES BETWEEN MODELS
- BEFORE USING THE MACHINE
- PRINTER
- TROUBLESHOOTING
- ROUTINE MAINTENANCE
- SYSTEM SETTINGS
- WEB FUNCTIONS IN THE MACHINE
- ABOUT THE WEB PAGES
- ABOUT THE WEB PAGES (FOR USERS)
- CONFIGURING THE PRINTER CONDITION SETTINGS
- ABOUT THE WEB PAGES (FOR THE ADMINISTRATOR)
- CONFIGURING SMTP AND DNS SERVER SETTINGS
- PROTECTING INFORMATION PROGRAMMED IN THE WEB PAGE ([Passwords])
- ADMINISTRATOR SETTINGS
- E-MAIL STATUS AND E-MAIL ALERT SETTINGS
- TRADEMARK ACKNOWLEDGMENTS
33
PRINTER
PRINTING ON ENVELOPES
The bypass tray can be used to print on special media such as envelopes. The procedure for printing on an
envelope from the printer driver properties screen is described below.
For the types of paper that can be used in the bypass tray, see "USEABLE PAPER" (P.13). For the procedure for
loading paper in the bypass tray, see "Loading the bypass tray" (P.17).
Select the envelope size in the appropriate settings of the application ("Page Settings" in many applications) and
then perform the following steps.
1
Select the paper size.
Select the envelope size from the "Paper Size" menu on the page setup screen.
2
Select the bypass tray.
(1) Select [Paper Feed] on the print screen.
(2) Select [Bypass Tray(Envelope)] from the "All Pages From" menu.
Set the bypass tray paper type to [Envelope] in the machine’s “Paper Type Setup”, and make sure that an envelope is
loaded in the bypass tray.
In the case of media that can only be loaded in a certain orientation such as an envelope, you can rotate the
image 180 degrees if needed. For more information, see "ROTATING THE PRINT IMAGE 180 DEGREES
(Rotate 180 degrees)" (P.45)".
It is recommended that you do a test print to check the print result before using an envelope.
Note
(1)
(2)
Note