Service manual

MX-FNX1/MX-PNX1 DISASSEMBLY AND ASSEMBLY 6 – 6
(13) Bundle exit motor
1) Remove the inner finisher from the main unit. Refer to A-(1).
2) Remove the inner cover. Refer to A-(2).
3) Remove the tray unit. Refer to B-(10).
4) Remove the bottom plate. Refer to B-(10).
5) Disconnect the connector, and remove the bundle exit motor.
(14) Paddle one-rotation solenoid
1) Remove the inner finisher from the main unit. Refer to A-(1).
2) Remove the inner cover. Refer to A-(2).
3) Remove the tray unit. Refer to B-(10).
4) Remove the bottom plate. Refer to B-(10).
5) Remove the paddle one-rotation solenoid.
C. Process tray section
(1) Alignment motors F and R
1) Remove the inner finisher from the main unit. Refer to A-(1).
2) Remove the inner cover. Refer to A-(2).
3) Remove the tray unit. Refer to B-(10).
4) Remove the load cover. Refer to B-(10).
5) Remove the bundle exit paper transport unit.
6) Remove each parts, and remove the sensor lever.
7) Remove the center weight, and remove the process tray unit.
1
2
3
1
1
1
2
1
2