Service manual

MX-FNX1/MX-PNX1 DISASSEMBLY AND ASSEMBLY 6 – 10
5) Remove the gear, and remove the tray motor.
(5) Tray paper empty sensor
1) Remove the inner finisher from the main unit. Refer to A-(1).
2) Remove the left cover and the bottom cover. Refer to A-(4).
3) Remove the tray bottom cover.
4) Pull out the tray. Remove the screw, and remove the tray.
5) Remove the tray paper empty sensor.
F. O t h er s
(1) Control PWB
1) Remove the inner finisher from the main unit. Refer to A-(1).
2) Remove the rear cover. Refer to A-(3).
3) Disconnect the connector, and remove the screw. Remove the
PWB support and remove the control PWB.
(2) Fan
1) Remove the inner finisher from the main unit. Refer to A-(1).
2) Shift the staple unit to the rear side. Disconnect the connector
and remove the fan.
* When installing, take care that the label of the fan comes to
the direction illustrated.
(3) Front cover switch
1) Remove the inner finisher from the main unit. Refer to A-(1).
2) Remove the inner cover. Refer to A-(2).
3) Remove the spring, and remove the interlock sensor lever.
Remove the front cover switch, and disconnect the connector.
1
2
1
2
3
2
3
2
3
1
2
3
4
Blue
Red
Yellow