Service manual

MX-FNX1/MX-PNX1 DISASSEMBLY AND ASSEMBLY 6 – 12

3) Remove the punch horizontal resist motor.

(4) Punch PWB

1) Remove the punch unit. Refer to A-(1).

2) Remove the guide cover and the harness guide. Refer to A-

(3).

3) Remove the punch PWB.

(5) Punch motor

1) Remove the punch unit. Refer to A-(1).

2) Disconnect the connector, and remove the link plate. Remove

the spring, and separate the upper unit and the lower unit.

3) Fit the gear hole with the screw position, and remove the

screw. Remove the punch motor.

(6) LED light emitting PWB

1) Remove the punch unit. Refer to A-(1).

2) Remove the lower unit. Refer to A-(5).

3) Remove the roller and the PWB holder. Remove the LED light

emitting PWB.

(7) Rear position sensor

1) Remove the punch unit. Refer to A-(1).

2) Remove the rear position sensor.