Operation Manual, User's Manual

1-118

BEFORE USING THE MACHINE►LOADING PAPER

Loading paper into the bypass tray (on the large capacity trays)

To replace the paper in the bypass

tray, press the operation button and

remove the paper.

The paper table goes down. The operation button blinks

while the paper table goes down. The button lights up when

the paper table has gone down. Do not remove the paper

until the button ceases blinking.

Adjust the bypass tray guides to the

size of paper to be loaded.

Grasp the guide lock lever to adjust the bypass tray guides

to the paper size. Be sure to adjust the bypass tray guides at

the rear end.

When loading paper larger than A4R or 8-1/2" × 11"R, be

sure to pull out the bypass tray extension. Remove the

bypass tray guide at the rear end and attach them to the

inserter tray.

• Pull the bypass tray extension all the way out.

• When loading paper larger than A3W, or 8-1/2" × 14", remove the bypass tray guides at the rear end.

Do not place heavy objects on the bypass tray or press down on the tray.

Insert the paper along the bypass tray

guides all the way into the bypass tray

until it stops and adjust the right-side

guide.

Load paper with the print side facing down.

The stack must not be higher than the indicator line.

A maximum of 500 sheets of paper can be loaded into the

tray.

• Do not force the paper in.

• If the bypass tray guides are set wider than the paper, move the bypass tray guides in until they correctly fit the width

of the paper. If the bypass guides are set too wide, the paper may skew or be creased.