Operation Manual, User's Manual

2-8
COPIER►BEFORE USING THE MACHINE AS A COPIER
Default settings for copying
Set in “Default Settings” of “Copy Settings” in the System Settings. You can set a default value for each copy setting.
Initial Status Settings selected
with these settings apply to all functions of the machine (not just the copy function).
The copier settings are reset to the initial state when the [Power
] button is turned on, when the [CA] key is tapped, or
when the auto clear interval has elapsed. These settings are used to change the default settings for copy mode.
The following settings can be change
d:
Item Description
Colour Mode Configure default colour mode settings.
Image Orientation Specify the original orientation.
Paper Tray Specify the paper tray that is selected by default.
Exposure Type Configure default exposure mode settings.
Copy Ratio Specify the copy ratio that is selected by default.
Select magnification
automatically according to paper
size, when paper tray is selected.
Enable magnification automatically in default when changing the paper tray.
2-Sided Copy
Configure the 2-sided mode settings that are selected by default.
If this setting is used to change the default setting for the duplex function to any setting
other than "1-Side to 1-Side" and the duplex function or automatic document feeder fails or
is disabled, the setting will revert to "1-Side to 1-Side".
Original Binding Set the original binding in 2-Sided copy.
Output Binding Set the output binding in 2-Sided copy.
Output Set the print output method and output tray that are selected by default.
Output Tray Specify the output tray.
Offset Set whether or not offset is performed in the default settings.
Separator Page
Separator pages can be inserted before or after jobs. Set the paper tray used for the
separator pages.
Staple Configure staple settings
Punch Configure punch settings
Fold Configure fold settings
Factory defaults This returns all items to the factory default settings.