Operation Manual, User's Manual

4-85
FACSIMILE►OTHERS FUNCTION
Original image in transaction report
When [Print Original Image] is enabled, the first page of the transmitted original is printed on the same sheet as the
transaction report. The original image is reduced to allow it to fit on the sheet. If the vertical scanning length (X direction)
of the original is longer than 432 mm (17-1/64"), the part that exceeds 432 mm (17-1/64") may be cut off.
To cancel the transaction report setting:
Tap the [Do not Print] key.
• The print conditions for a transaction report are as follows:
•"Always Print": A transaction report is printed no matter whether the transmission succeeds or fails.
•"Print at Error": A transaction report is printed when transmission fails.
•"Do not Print": Do not print a transaction report.
• Set the [Print Original Image] checkbox to to include the first page of the transmitted original in the transaction
report.
• Even if the [Print Original Image] checkbox is , the original cannot be printed when speaker dialling, manual
transmission, direct transmission, polling reception, or F-code transmission is used.
5
Tap the [Start] key to start scanning of the original.
• If you inserted the original pages in the document feeder tray, all pages are scanned.
• A beep will sound to indicate that scanning and transmission have ended.
• When you place the original on the document glass, scan each page one at a time.
• When scanning finishes, place the next original and tap the [Start] key. Repeat until all pages have been scanned and
then tap the [Read-End] key.
A beep will sound to indicate that transmission has ended.
You can tap the [Preview] key to check a preview of the image before sending a fax. For more information, see
"CHECKING THE IMAGE TO BE TRANSMITTED (pag
e 4-30)". However, settings for this function cannot be changed
in the preview screen.