Setup Manual

EN 4
Accessories
Supplied Accessories
Make sure the following accessories are provided
with the product.
Remote control unit (x 1)
Remote control unit battery (x 2)
AC cord (Type BF) (x 1)
AC cord (Type C) (x 1)
AV terminal conversion cable (x 1)
Cable clamp (x 5)
Setup Guide (this document) (x 1)
Stand (x 1 set)*
Wall mounting bracket (x 1 set)*
Eyebolt cover (x 2)*
Eyebolt cover attachment screw (x 2)*
* Consult your dealer for installation of the stand or wall
mounting bracket.
* For environmental protection!
Do not dispose of batteries in household waste. Follow
the disposal instructions for your area.
NOTE
The supplied AC cord is dedicated for this product. Do not
use it for other equipment.
Preparation and How to Use Remote Control Unit
Inserting Batteries into the Remote
Control Unit
1
Place your finger on the part marked with the
s
,
and then pull the cover off.
2
See the instructions in the compartment and put
in the batteries (R03 or LR03 (“AAA” size) x 2) with
their plus
(+)
and minus
(-)
sides oriented correctly.
3
Close the cover.
NOTE
Do not apply impact on the remote control unit. Avoid water
and do not place the product in areas with high humidity.
If the remote control unit occasionally does not respond, the
batteries may be running out. Replace them ahead of time.
The supplied batteries may run out in a short period of time
depending on the storage condition.
Use manganese or alkaline batteries only.
Check the cell batteries of the remote control unit once in
six month for abnormality such as leakage and distortion.
The remote control may not function properly after a
leakage occurs.
1
30°
30°
18°
30°
17´ (5 m)
Remote control light
receiving section
Range of Remote Control Operation
Check the range and distance of both the remote
control unit and the Monitor, and press one button on
the remote control unit at a time.
CAUTION
Do not place objects in the area under the Monitor.
Obstacles may interrupt the receiver of the remote control and
may result in misoperation.