MX-5500N/6200N/7000N Operation-Manual Copier GB
Table Of Contents
- TABLE OF CONTENTS
- ABOUT THIS MANUAL
- BEFORE USING THE MACHINE AS A COPIER
- BASIC PROCEDURE FOR MAKING COPIES
- SPECIAL MODES
- SPECIAL MODES
- ADDING MARGINS (Margin Shift)
- ERASING PERIPHERAL SHADOWS (Erase)
- COPYING EACH FACING PAGE OF A BOUND DOCUMENT (Dual Page Copy)
- MAKING COPIES IN PAMPHLET FORMAT (Pamphlet Copy)
- COPYING A LARGE NUMBER OF ORIGINALS AT ONCE (Job Build)
- USING TWO MACHINES TO MAKE A LARGE NUMBER OF COPIES (Tandem Copy)
- USING A DIFFERENT PAPER TYPE FOR COVERS (Covers/Inserts)
- ADDING INSERTS WHEN COPYING ON TRANSPARENCY FILM (Transparency Inserts)
- COPYING MULTIPLE ORIGINALS ONTO ONE SHEET (Multi Shot)
- COPYING A PAMPHLET (Book Copy)
- COPYING CAPTIONS ONTO TAB PAPER (Tab Copy)
- COPYING BOTH SIDES OF A CARD ON ONE SHEET OF PAPER (Card Shot)
- PRINTING THE DATE AND A STAMP ON COPIES (Stamp)
- [Image Edit] KEY
- [Colour Adjustments] KEY
- CHECKING COPIES BEFORE PRINTING (Proof Copy)
- COPYING ORIGINALS OF DIFFERENT SIZES (Mixed Size Original)
- COPYING THIN ORIGINALS (Slow Scan Mode)
- CONVENIENT COPY FUNCTIONS
59
3
Set the number of copies (number of
sets) with the numeric keys.
Up to 999 copies (sets) can be set. When the [COLOUR
START] key ( ) or the [BLACK & WHITE START] key
( ) is pressed, the copies will automatically be divided
between the master and slave machines.
If an odd number of copies is set, the master machine will print
the extra set.
If an incorrect number of copies is set...
Press the [CLEAR] key ( ) and then enter the correct number.
4
Press the [COLOUR START] key
( ) or the [BLACK & WHITE
START] key ( ).
Copying will begin.
If you are using the document glass, change originals and
press the [START] key. Repeat until all pages have been
scanned and then touch the [Read-End] key. (For the second
original and following originals, use the same [START] key as
you did for the first original.)
The following screen appears when the [START] key is
pressed.
After the message appears, tandem copying begins.
If tandem copying is not possible, the following screen appears.
To have the master machine make all copies, touch the [OK]
key. To cancel the job, touch the [Cancel] key.
• To cancel scanning...
Press the [STOP] key ( ).
• To cancel tandem copying...
Touch the [STOP] keys ( ) on both the master machine and the slave machine.
or
Starting tandem operation.
Please wait.
Tandem output is not allowed.
Output all sets using master machine?
(Cancel will delete the job.)
Cancel
OK