MX-5500N/6200N/7000N Operation-Manual Facsimile GB
Table Of Contents
- TABLE OF CONTENTS
- ABOUT THIS MANUAL
- BEFORE USING THE MACHINE AS A FAX
- ENTERING DESTINATIONS
- BASIC TRANSMISSION METHODS
- FAX RECEPTION
- SPECIAL MODES
- SPECIAL MODES
- STORING FAX OPERATIONS (Program)
- ERASING PERIPHERAL SHADOWS ON THE IMAGE (Erase)
- TRANSMITTING AN ORIGINAL AS TWO SEPARATE PAGES (Dual Page Scan)
- SENDING A FAX AT A SPECIFIED TIME (Timer)
- SENDING TWO PAGES AS A SINGLE PAGE (2in1)
- SENDING BOTH SIDES OF A CARD AS A SINGLE PAGE (Card Shot)
- SENDING A LARGE NUMBER OF PAGES (Job Build)
- TRANSMITTING ORIGINALS OF DIFFERENT SIZES (Mixed Size Original)
- FAXING THIN ORIGINALS (Slow Scan Mode)
- ADDING YOUR SENDER INFORMATION TO FAXES (Own number sending)
- CALLING A FAX MACHINE AND INITIATING RECEPTION (Polling)
- SENDING A FAX WHEN ANOTHER MACHINE POLLS YOUR MACHINE (Polling Memory)
- PERFORMING F-CODE COMMUNICATION
- USING AN EXTENSION PHONE
- CHECKING THE STATUS OF FAX JOBS
- PRINTING A TRANSACTION REPORT / IMAGE SENDING ACTIVITY REPORT
- IF THE MACHINE IS MOVED
81
6
Touch the [Read-End] key.
• If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the
transmission is reserved.
• The [Configure] key can be touched to change the exposure, resolution, scan size, and send size for each original
page scanned. However, when Job Build is used in combination with 2in1 in the special modes, only the exposure
can be changed when scanning each even-numbered page of the original pages.
• If the memory becomes full during scanning, a message will appear and the transmission will be cancelled.
• This function cannot be used in direct transmission mode or when the speaker is used to dial.
To cancel Job Build....
Touch the [Job Build] key in the screen of step 2 so that it is not highlighted.
Place next original.
Press [Start].
When finished, press [Read-End].
(Pg.No.x)
Configure Read-End