MX-5500N/6200N/7000N Operation-Manual System-Settings-Guide GB

36
* When a saddle stitch finisher is installed.
■ Network Settings
X Initial Margin Shift Setting
66 Side 1 10 mm (1/2")
 Side 2 10 mm (1/2")
X Erase Width Adjustment
66 Edge Clearance Width 10 mm (1/2")
 Centre Clearance Width 10 mm (1/2")
X Card Shot Settings
66 Original Size X: 86 mm (3-3/8"), Y: 54 mm (2-1/8")
 Fit to Page Disabled
X Automatic Saddle Stitch* Enabled 66
X Initial Tab Copy Setting 10 mm (1/2") 66
X Disabling Deletion of Job Programs Disabled 67
X Disabling of Bypass-Tray in Duplex Copy Disabled 67
X Disabling of Auto Paper Selection Disabled 67
X Auto Selection Setting of Tray that is Supplied the Paper Disabled 67
X B/W 600dpi x 600dpi Scanning Mode for Document Feeder Disabled 67
X B/W Quick Scan from Document Glass Enabled 67
● Colour Adjustments 68
X Initial Colour Balance Setting Factory default state 68
X Auto Colour Calibration – 68
Item Factory default setting Page
■ Network Settings
69
● IP Address Setting DHCP 69
● Enable TCP/IP Enabled 69
● Enable NetWare Enabled 69
● Enable EtherTalk Enabled 69
● Enable NetBEUI Enabled 69
● Reset the NIC – 69
● Ping Command – 69
Item Factory default setting Page