MX-M700U/N Operation-Manual Setup-Guide GB

29
This chapter explains how to install the PPD file to enable printing from a Macintosh and how to configure the printer
driver settings.
☞ MAC OS X: this page
(v10.1.5, v10.2.8, v10.3.9, v10.4 - v10.4.8)
☞ MAC OS 9.0 - 9.2.2: page 34
MAC OS X
1
Insert the "Software CD-ROM" into your
computer's CD-ROM drive.
Insert the "Software CD-ROM" that shows "Disc 2" on the
front of the CD-ROM.
2
Double-click the [CD-ROM] icon ( ) on
the desktop.
3
Double-click the [MacOSX] folder.
Before installing the software, be sure to read "ReadMe
First". "ReadMe First" is in the [US-English] folder
([English] folder in areas other than the U.S.) in the
[Readme] folder.
4
Double-click the folder corresponding
to the versions of the operating system.
5
Double-click the [MX-B01] icon ( ).
6
Click the [Continue] button.
3
SETUP IN A MACINTOSH
ENVIRONMENT
• To use the machine as a printer in a Macintosh environment, the PS3 expansion kit is necessary. In addition, the
machine must be connected to a network. On the MX-M550U/M620U/M700U, the network expansion kit is
required. A USB connection cannot be used.
• The PC-Fax driver cannot be used in a Macintosh environment.
The explanations of screens and procedures are primarily for Mac OS X v10.4. The screens may vary in other versions of the
operating system.
v10.2.8
v10.4 -
10.4.8
v10.3.9
v10.1.5
• If the "Authorization" window appears in Mac OS X
v10.1.5, click the lock icon ( ), enter the
password, and click the [OK] button.
• If the "Authenticate" window appears in Mac OS X
v10.2.8, enter the password and click the [OK]
button.
03_Setup.fm 29 ページ ２００７年１月１２日 金曜日 午後１時４６分