MX-M700U/N Operation-Manual Setup-Guide GB

37
IF THE SOFTWARE CANNOT BE INSTALLED
The machine is not
detected (when
connected to a
network).
Is the machine power on? If the machine is powered off, it will not be detected.
Switch on the main power switch and power switch in
that order. (In Windows, search again after powering on
the machine.)
Is your computer connected correctly to
the machine?
Make sure that the cable is connected securely to the
LAN connectors on your computer and the machine.
Check the connections at the hub as well.
☞ CONNECTING THE MACHINE TO A NETWORK
(page 7)
The plug and play
screen does not
appear (USB
connection in
Windows).
Is the machine power on? When a USB cable is connected, make sure the power
of the machine is "ON" and then connect a USB cable to
the machine. When the machine is not powered on,
switch on the main power switch and power switch in
that order.
Can your computer use a USB
connection?
Check your computer whether or not a USB interface
can be used on the Device Manager in your computer.
(For information on "Device Manager", see Help in
Windows.)
If USB can be used, your controller chipset type and
root hub will appear in "Universal Serial Bus controllers"
in "Device Manager". (The items that appear will vary
depending on your computer.)
If these two items appear, USB should be useable. If a
yellow exclamation point appears next to "Universal
Serial Bus controllers" or the two items do not appear,
refer to your computer manual or check with the
manufacturer of your computer to enable USB and then
reinstall the printer driver.
The printer driver is
not installed correctly
by plug and play (USB
connection in
Windows).
Did you connect the machine to your
computer before installing the printer
driver?
In Windows 2000/XP/Server 2003, if the machine was
connected to your computer with a USB cable before
the printer driver was installed from the installer, check if
information on the unsuccessful installation remains in
"Device Manager". (For information on "Device
Manager", see Help in Windows.)
If the model name of the machine appears in "Other
devices" in "Device Manager", delete it, restart your
computer, and install the printer driver again.
Problem Point to check Solution
!mx7000_us_ins.book 37 ページ ２００６年１０月１８日 水曜日 午前１０時３３分