Instruction manual

CONNECTION
To connect the MZ disk drive to an MZ-700 series computer, perform the
following.
1. Remove the data recorder, or the cover (for MZ-711 or MZ-710).
1) Turn off the power switch of the computer and unplug the AC cord.
Remove the
two screws holding the data recorder from the left rear side of
the computer. Lift the data recorder out of its mounting. (Figure 1)
2) Remove the connector
(CN1) between the data recorder and the MZ-700
series computer. (Figure 1 )
Data recorder
Figure 1
Note:
When the data recorder is to be used, connect it to the MZ-1 F11 con-
nector. (See Figure 4 for details.)
- 3 -