DIGITAL MULTIMEDIA PROJECTOR OPERATION MANUAL MODEL PG-M25X
Image Projection
Basic Procedure
Connect the required external equipment to the
projector before operating the following procedures.
Details are found in the projector operation
manual.
Info
•
The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 37.
1
Plug the power cord into the wall outlet.
•
The POWER indicator illuminates up in red,
and the projector enters standby mode.
2 Press on the projector or
on the GyroRemote.
• The POWER indicator illuminates in
green. After the LAMP REPLACEMENT
indicator illuminates, the projector is
ready to start operation.
Note
• The LAMP REPLACEMENT indica-
tor illuminates, indicating the status
of the lamp.
Green: The lamp is ready.
Green blinking: The lamp is
warming up.
Red:
The lamp should be replaced.
•
If the power is turned off and
immediately switched on again, the
LAMP REPLACEMENT indicator may
take time to
illuminate
.
When “Anti-Theft” (see page 102) is
set, the keycode input box will appear.
• Enter the keycode.
Note
• When entering the keycode, press
the buttons previously set on the
projector or the GyroRemote.
Info
•
When “Anti-Theft” is set, enter the
keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (See page 102.)
▼Projector indicators
LAMP REPLACEMENT indicator
POWER indicator
POWER button
INPUT
button
INPUT button
POWER button
▼Keycode input box
-34
Volume
buttons
AV MUTE
button
Volume button
PG-M25X#E#p33_49.p65 02.4.29, 3:11 PM34