Installation Manual

2 8
6
INSTALLATION WORK
4. Remove the lower tile from the roof.
5. Place the roof tile slider on the lower tile and align with
the horizontal line marked above. Mark two holes for
roof tile stand off.
Hole guide line
S Tile
(holes in valley)
Low Profile Tile
(holes in center)
Flat Tile
(holes in center)
Roof tile slider
AE-110
1
Align the end with
the hole guide line
Front row,
holes 1 & 3
Middle row,
holes 2 & 4
Top row,
holes 3 & 5
Drill guides.
Never use drill
guide holes
for tile roof
standoff screw
6. Drill 2 holes using supplied drill bit (AE112). A high
speed drill (approximately 1000 rpm) is required for
this process. Exert a pressure of 40 to 50 lb. Make
certain to dip the tip of the drill in water after drilling
each hole. This will cool the drill bit. Clean any debris
and dust after drilling.
Press down with about
40 - 50 lb of force.
Cool the drill bit
after drilling one
or two holes.
This will prolong
the life of the
drill bit.
Gather the tile
dust with a
vacuum cleaner
or brush & pan
CAUTION
Drill holes on the ground for safety reason.
7. Locate the rafter and place the aluminum support plate
on the deck. Install two 80 mm screws (XA02) through
the plate, spaced ~ 5" apart, into the rafter. Install four
35 mm screws (XA27) through the plate and into the
deck. The screws should be spaced equally along the
upper and lower edges of the plate.
Support AL screw (XA-27) 5.5 x 35
(into decking)
Standard slider
mounting screw
(XA-02) 5.5 x 80
(into rafters)
Aluminum support plate
(AK-111)
Standard slider
mounting screw
(XA-02) 5.5 x 80
Rafter chalk line
Rafter chalk line
Align the end of the
aluminum support plate
against the upper tile.
Pitch approx. 5”
Aluminum support
plate (AK111)
Support AL screw
(XA-27) 5.5 x 35
(into decking)
Support AL screw (XA-27) 5.5 x 35
(into decking)
Standard slider
mounting screw
(XA-02) 5.5 x 80
(into rafters)
Aluminum support plate
(AK-111)
Standard slider
mounting screw
(XA-02) 5.5 x 80
Rafter chalk line
Rafter chalk line
Align the end of the
aluminum support plate
against the upper tile.
Pitch approx. 5”
Aluminum support
plate (AK111)
Support AL screw
(XA-27) 5.5 x 35
(into decking)