Installation Manual

2 9
6
INSTALLATION WORK
8. Place 2 butyl pads under the holes drilled in the tile.
The butyl should be located on the underside of the
tile. Reinstall the tile on to the roof according to the
locations marked previously.
Bottom side of the tile
Be sure to align
the center of the holes
in tile and butyl pad.
Bottom butyl pad
(AE105)
Remove brown
backing paper to
expose sticky side.
Adhere the sticky side
of the butyl pad to
bottom side of tile.
9. Inject Sharp supplied silicone caulk (AE107) into the
holes to form a dome. The dimensions of the dome
are ~ 0.75" in height and 1.5" in diameter.
Fill the hole with caulk.
Silicone caulk
Bottom butyl pad
Tile
CORRECT WRONG
10. Insert 2 top butyl pads onto the tile standoff legs.
Top butyl pad
AE106
Remove
paper backing
Tile roof stand off
AE104
Insert
11. Insert the tile roof stand off into the drilled holes until
it rests on top of the aluminum support plate.