Installation Manual

5. Install entire row of modules.
6. Push the rail towards the eave
of the roof to tighten the fit of
the row of modules. This will
eliminate all gaps between
the modules and rails.
7.
Tighten the rail bolts to fully
secure the solar modules
and rail.
8.
Place the module clips (AD801)
on the rail. Two clips are
required for each rectangular
module.
Secure each clip with an M8
bolt and AD105 threaded tab.
Co
ntinue this process until all
rows have been installed.
EAVE
EAVE
Rail
Module
mounting clip
Previous row of
solar modules
6.12 INSTALLING TOP COVER
1. Place rail cover at an angle to engage the rail clip. 2. Rotate the rail cover to fully engage the rail clip.
Side cover
screw
3. Insert the screw into the threaded tap and screw
into place.
Module
mounting
clip fastener
Note 2 clips to secure front cover
Front cover
half size
6
INSTALLATION WORK
3 53 5