Specifications

2-4 Running the Setup Utility
2
Diskette A This setting should generally be set to 1.44MB,3½".
Hard Disk Type Determines the type of the internal hard disk. If it is set to Auto, the
type of the new hard disk will automatically be identified when the hard disk is
replaced.
Boot Sequence Determines where the boot program will look for operating system
files. The default is C: then A:, which checks the hard disk first, and only checks the
floppy disk drive if no system files are found on the hard disk.
Other options for this setting are A: then C:, which check the floppy disk drive (A:)
first, and if no system disk is found in the drive, the system boots from the hard
drive; C: only, which never checks for system files on the floppy disk drive.
Internal Numlock If you are using an external keyboard, you may want to use the
external keyboard’s NumLock key. The NumLock key of the external keyboard also
effects the built-in keyboard, and the built-in keyboard turns on the NumLock status.
To avoid this, set this option to Disabled before using the NumLock key on an
external keyboard.
Key Click Enables or disables audio feedback of key click.
Video Input Determines whether you use the built-in capture board or the ZV port.
System Memory Indicates the size of ‘conventional’ memory to be made available
directly to MS-DOS. It always shows 640 KB.
Extended Memory Indicates the size of extended memory found by the BIOS
during its POST. The value displayed is the amount of memory located above 1MB
in the microprocessor’s memory address map. Because the notebook ships with a
minimum of 16MB of memory as standard, this value will not be less than 15360KB.
The notebook automatically updates the value here when you enter the Setup Utility
after you add an optional memory module.