Specifications

3-24 Modem
3
Modem
You can use the modem built in your notebook, for data transfer, fax communication
and voice communication.
Connecting the Modem to Telephone Line
1. Connect one end of the attached modem cable to the modem jack on the right
side of your notebook.
2. Connect another end of the cable to the telephone line.
Using Communication Software
To use communication software,
1. Turn on your notebook.
2. Press the F2 key when the message Press <F2> to enter Setup appears.
3. On the Advanced page of the Setup Utility, set the COM1/COM2 Function to
FAX Modem/IR or Serial Port/FAX Modem.
4. If you assign the modem to COM1, set the COM1 Port to 3F8, IRQ4. If you
assign the modem to COM2, set the COM2 Port to 2F8, IRQ3.
5. On the Power page of the Setup Utility, set Suspend Mode to Suspend to RAM.
6. Set Modem Power when Suspend RAM to Enabled.
7. Set Auto Suspend to Disk to Disabled.
8. Press the Esc key and select Save Changes & Exit.
9. In the communication software, set the items such as COM ports, baud rate, etc.
Refer to the software manual or online help or the manual of Windows 95.
(When using commands, refer to AT Command Reference Manual.)
The modem is available in the U.S. only.