System information

5 Injector System
www.turnerbiosystems.com 33
1. Power off the Modulus™ Microplate Reader.
2. Place the Injector System Console on top of the instrument with
the four rubber feet firmly inside of the indentation and level.
3. Remove the black rectangular plate located behind the touch
screen by loosening the two screws with the provided Allen
wrench.
4. Drop the injector tip end(s) of the outlet tubing assembly
through the opening of the instrument as shown.
5. The black plate connected to the injector tip should be oriented
so that the screw holes are aligned with the angle found on the
instrument. Tighten the two black screws with the provided
Allen wrench.
Figure 5-2
: A Complete Injector System on Top of a Modulus
Microplate Reader