Specifications

7. To prevent the display from falling, tighten the screws at two points evenly. (The appropriate choice of fixing screws

depends on the material, structure, and strength of the table. Use high-quality screws.)

¶ First read the instruction manual. Observe the following points when attaching the stand frame to the

plasma display.

1.Use 45-mm bolts (shorter bolts).

2.Before securing the display with the bolts, verify that the positions of the display nuts match the bolt hole

positions in the stand frame.

3.When mounted to the stand frame, the display must have zero clearance and/or backlash to the stand frame,

or the plasma display nut will be damaged (Fig.1). Loosen the four bolts securing the joint pipe, as indicated by

the arrow, and adjust to remove any clearance or backlash. Then mount the display (Fig.2).

7 Angle adjustments

(Variable up to 20° from vertical)

Do not loosen this

screw.

Loosen these screws on the left

and right sides and decide on the

angle you want. Then, tighten

the screws.

7 Backlash adjustment

If the stand frames placed on the table have backlash,

adjust the fixture.

1. Loosen the 4 screws used to attach the joint pipes.

2. Adjust the stand frames to eliminate backlash beween

the table and the stand frames, and then tighten the

loose screws.

Fig. 1 Fig. 2

Precautions for assembly

Clearance, backlash

How to mount standard optional items (PDK-4001)

Be sure to anchor it with two bolts so that it will not fall.