Specifications

4
Connecting a Serial Mouse
1. Turn off the notebook.
2. Open the connector compartment cover on the rear side.
3. Connect the serial mouse to the RS-232C serial port. Tighten the screws if
they are present.
RS-232C Serial Port
Figure 4-4. Connecting a Serial Mouse
5. Turn on the notebook.
6. When the message Press<F2> to enter SETUP appears, press F2.
7. In the Advanced menu of the Setup Utility, set the GlidePoint (PS/2 Mouse) to
Disabled.
8. Press Esc; then, Enter twice.
9. From the Start menu, select Settings - Control Panel.
10. Double-click Mouse.
11. Click the General Tab; then, Change.
12. Select the manufacturer and model name, and click OK; then, Close.
13. Click Yes, and the notebook restarts.
When the serial mouse is active, you cannot use the GlidePoint nor a
PS/2 mouse.
Peripherals 4-5