Specifications

<Ver. 2.1>

Special installation (Wall hanging (vertically wall-hanging equipment))

3.4.10 Wall hanging (vertically wall-hanging equipment)

This display is designed to accommodate a range of wall installations. For this type of installation, carefully consider all

installation specifics before beginning work, since these factors can significantly affect the temperature of the air

surrounding the display. Please observe the following requirements:

1 Use plate metal that keeps all single holes clear and has dimensions no larger than those given in the following

table.

2 Leave adequate ventilation space between the wall and the display.

3 Mount a metal plate with sufficient strength at each of the four positions indicated in the following figure (four-

point stopping).

Mounting the display on the wall involves danger. Be sure to take double safety measures.

4 Recommended ambient operating temperatures are listed in the following table. Operate the display within this

temperature range.

5 The surface of the wall should closely approximate a perfectly flat plane. Keep deformation pressures on the

display, such as twisting and bending, at or below 1 mm.

Do not block this area on either the top or the bottom.

40mm

Do not block this area to the left or right.

40mm

Wall

75mm

694 mm (center indicated)

75mm

Clearance A to the wall

100 mm or more

50 mm or more

Less than 100 mm

0 to less than 50 mm

Ambient operating temperatures

0 to 35 °C

0 to 30 °C

Cannot be used.

Remarks