Specifications

5-5
5
LAN unit
Your computer is equipped with a 100 Base-TX/10 Base-T LAN interface. To
activate the LAN adapter, perform the following steps.
1. Turn off the computer.
2. Connect one end of the LAN cable into the LAN jack on the rear side of the
computer.
3. Connect the other end of the LAN cable into the network hub.
LAN Jack
To Network
4. Turn on the notebook.
5. When
Press <F2> to enter SETUP
appears, press
F2
.
6. In the Advanced menu, enable
LAN
.
7. Press
Esc
; then
Enter
twice. The system restarts.
8. In the
Network
dialog box, set fields according to your network status. Refer to
your network administrator.
• You cannot use the LAN unit when your notebook is in MS-DOS mode.
• You cannot use the LAN unit when you connect an optional external
battery(CE-BL03).
If you cannot access the network,
1. From the
Start
menu, select
Settings – Control Panel
.
2. Double-click the
Network
icon.
3. In the
Network
dialog box, select
Configuration
tab.
4. Click
Realtek RTL8139 xxxxxx
; then
Properties
.
5. Click
Advanced
tab, and select
Link Speed/Duplex Mode
in
Property:
and enter
an appropriate value in
Value:
.
6. Click
OK
twice and restart your computer.